Uraninite
Uraninite is uranium oxide, UO2: cubic, hardness 5–6, density 10.63–10.95, down to 6.5 when oxidised. How it compares with thorianite, cassiterite, ferberite.
Uraninite is uranium oxide, UO2 on the September 2026 IMA list, 88.15% uranium by mass. Its Handbook sheet gives cubic crystals to 11 cm, hardness 5–6, a brownish black to olive-green streak and density 10.63–10.95, “decreasing markedly with oxidation, to as low as 6.5”. Thorianite, ThO2, is its series partner; the sheet calls it “Radioactive.”
In short
- What it is. The September 2026 IMA-CNMNC Master List lists uraninite as UO2, grandfathered, 1845, Czech Republic, and the Handbook of Mineralogy sheet writes the same and names it “For URANium in the composition.” Worked, UO2 is 88.15% uranium, the figure on is uraninite the same as uranium, which covers the mineral-versus-element question and pitchblende; neither is repeated here.
- The black-and-heavy check. Computed from the printed densities, a 20.00 g piece of fresh uraninite reads 18.12–18.17 g in water. Of the five comparison minerals on cached sheets, only thorianite, 17.94–17.96 g, comes within 0.2 g; ferberite reads 17.36 g, cassiterite 17.13–17.15 g, and magnetite and hematite 16.14 and 16.20 g. Streak then splits the low end: black for magnetite, cherry-red for hematite.
- Documented failure: oxidation. The sheet says density falls “to as low as 6.5”: 16.92 g for 20.00 g, below cassiterite and ferberite and only 0.79 g above magnetite. An altered uraninite therefore lands among its look-alikes on the balance. And the gap to thorianite, 0.16 g, is too small to trust; the two sheets’ streaks overlap in gray and green, and the thorianite sheet prints “diamagnetic” where USGS Open-File Report 99-529 pulled uraninite at 0.20 to over 1.70 amps, “dc”.
- What else is in it. The sheet’s Placer de Guadalupe analysis prints 22.69% UO3 beside 70.09% UO2 and only 0.20% ThO2 and 0.40% PbO; its microprobe analysis prints 14.3% ThO2 and 13.9% PbO, which the sheet writes as (U4+0.48U6+0.18Pb0.16Th0.15Ca0.01Ce0.01)Σ=0.99O2.01. Rare-earth and yttrium oxides total 5.14 wt% in the first analysis. The sheet says it “may form an important ore”.
- Radioactivity: one line. The sheet prints “Radioactive.”; questions go to is my mineral radioactive and how to store radioactive mineral specimens, and nothing here is health, safety or legal advice. We hold no catalogue and nothing here is offered for sale; the wanted list is the only commercial route.
| Mineral | IMA formula | Density (sheet) | 20.00 g in water | Hardness | Streak (sheet) | Magnetic wording (sheet) | USGS best range, amps |
|---|---|---|---|---|---|---|---|
| Uraninite, fresh | UO2 | 10.63–10.95 | 18.12–18.17 g | 5–6 | Brownish black, gray, olive-green, shining | None printed | 0.50 to over 1.70, dc (4 samples) |
| Thorianite | ThO2 | 9.7–9.8 | 17.94–17.96 g | 6.5–7, unaltered | Gray to greenish gray | “diamagnetic” | No row |
| Ferberite | Fe2+(WO4) | 7.58 | 17.36 g | 4–4.5 | Brownish black to black | “Slightly magnetic” | 0.40 (4 samples) |
| Cassiterite | SnO2 | 6.98–7.01 | 17.13–17.15 g | 6–7 | White, pale brown, pale gray | None printed | Over 1.70 (6 samples) |
| Uraninite, oxidised | UO2 | As low as 6.5 | 16.92 g | — | — | — | — |
| Hematite | Fe2O3 | 5.26 | 16.20 g | 5–6 | Cherry-red or reddish brown | None printed | 0.10–0.30 (11 samples) |
| Magnetite | Fe2+Fe3+2O4 | 5.175 | 16.14 g | 5.5–6.5 | Black | “Strongly magnetic” | 0.01 (6 samples) |
| Pitchblende (USGS row name) | No IMA line | — | — | — | — | — | 0.50–0.90, dc (2 samples) |
What is uraninite? The formula and the sheet
Formula and name. The September 2026 IMA-CNMNC Master List lists uraninite as UO2, status G, 1845, Czech Republic, and the Handbook of Mineralogy uraninite sheet writes UO2 and explains the name: “For URANium in the composition.” Worked on standard atomic weights, UO2 is 270.03 and 88.15% uranium by mass; the sheet’s two analyses work out at 80.67% and 60.80%. Those figures agree with is uraninite the same as uranium, which sets out why uraninite and uranium are different words and how pitchblende fits; this page does not repeat it.
In the hand. Cubic, point group 4/m −3 2/m; crystals uncommon, “typically cubes modified by the octahedron and dodecahedron, to 11 cm”; also botryoidal to reniform, colloform banded, columnar or dense massive, and sometimes dendritic. Hardness 5–6, brittle, uneven to conchoidal fracture; steel-black to velvet-black, brownish black, pale gray or pale green; streak brownish black, gray, olive-green, shining; submetallic to greasy or dull; isotropic. The sheet’s cell, a = 5.4682 Å for synthetic UO2.03, gives 10.97 for UO2 at Z = 4 by script, a little above the printed calc. 10.88 and the measured top of 10.95: the printed cell is not the analysed material.
How heavy is uraninite? The black-and-heavy check
The rule. Computed from the printed densities, 20.00 g of fresh uraninite would read 18.12–18.17 g in water. Of the five dark, heavy comparison minerals in the table, only thorianite’s 17.94–17.96 g comes within 0.2 g. Ferberite reads 17.36 g and cassiterite 17.13–17.15 g, at least 0.58 g below thorianite; magnetite and hematite read 16.14 and 16.20 g, and streak separates those two, black against cherry-red. So, on paper, a fresh black specimen above about 17.9 g for 20 g sits with uraninite or thorianite, and one between 17.1 and 17.4 g with cassiterite or ferberite. The method is on how to measure specific gravity at home; it is arithmetic, not an instruction to handle anything.
Magnetism. The uraninite sheet prints no magnetic property. USGS Open-File Report 99-529 Table 1 pulled 4 uraninite samples at 0.20 to over 1.70 amps, best 0.50 to over 1.70, and marks the row “dc”, which the report defines as “a large difference in extraction among the samples run”; its separate “Pitchblende” row, 2 samples, ran 0.40–1.00, best 0.50–0.90, also dc. The report calls paramagnetic minerals “separable in magnetic separators with field currents up to 1.70 amps” and diamagnetic ones “nonmagnetic at 1.70 amps.”, so uraninite spans both. It is nowhere near magnetite’s 0.01 amp; the site-wide comparison is on which minerals are magnetic.
Where the check fails: oxidised uraninite and thorianite
Documented failure: oxidation moves it. The sheet’s own density line runs from 10.63–10.95 “decreasing markedly with oxidation, to as low as 6.5”. At 6.5 a 20.00 g piece reads 16.92 g in water, 0.21 g under cassiterite’s lowest and 0.79 g above magnetite. Altered uraninite is therefore indistinguishable on the balance from the minerals the rule is meant to exclude, and only a fresh, unaltered piece fits the top of the ladder. The Placer de Guadalupe analysis shows how much oxidised uranium a real specimen carries: 22.69% UO3 beside 70.09% UO2.
Documented failure: the series partner. Thorianite, ThO2 on the IMA list and 87.88% thorium worked, “Forms a series” with uraninite on the uraninite sheet, and the uraninite X-ray pattern “may be confused with thorianite or cerianite”. In water the two differ by 0.16 g at 20 g. Their streaks overlap, brownish black to olive-green against gray to greenish gray, and the thorianite sheet prints hardness 6.5–7 “unaltered” and “diamagnetic”, neither of which a collector can rely on at the boundary. The sheet’s microprobe uraninite carries 14.3% ThO2: telling one from the other needs an analysis.
Where is uraninite found? Cornwall to Katanga
The Distribution field. The sheet calls uraninite “Widespread; may form an important ore.” It names Jáchymov (Joachimsthal) and Horní Slavkov (Schlaggenwald), Czech Republic; Johanngeorgenstadt, Schneeberg and Annaberg, Saxony, and Wölsendorf and Hagendorf, Bavaria; “many mines in Cornwall, England”; large crystals from the Sierra Albarrana, Córdoba, Spain; Wilberforce, Ontario, and Great Bear Lake, Northwest Territories; Branchville, Connecticut, Grafton, New Hampshire, fine crystals from Standpipe Hill, Topsham, Maine, Spruce Pine, North Carolina, and the Ingersoll mine, South Dakota; Shinkolobwe and Kalongwe in the Katanga Copperbelt; and Morogoro, Tanzania. No individual Cornish mine is named on the sheet, and none is named here.
Setting. Granite and syenite pegmatites, with zircon, monazite, tourmaline, mica and feldspar; high-temperature tin veins and moderate-temperature Co–Ni–Bi–Ag–As sulfide veins, with pyrite, chalcopyrite, galena, bismuth, silver, nickeline, barite and fluorite; Colorado Plateau-type sandstone-hosted U–V deposits; uraniferous conglomerates; and as a detrital mineral. Other uranium minerals, such as torbernite and autunite, have their own pages. More species are in the species index. We hold no catalogue and nothing here is offered for sale; the wanted list is the only commercial route.