Xonotlite
Xonotlite is calcium silicate hydrate, Ca6Si6O17(OH)2: exactly six CaSiO3 plus one water, 2.52% H2O. Hardness 6–6.5, density 2.71–2.72, tough, fibrous rosettes.
Xonotlite is a calcium silicate hydrate, Ca6Si6O17(OH)2 on the September 2026 IMA list: worked, exactly six formula units of wollastonite, CaSiO3, plus one water, 2.52% H2O by mass. Its Handbook sheet gives monoclinic needles to 2 cm and fibrous rosettes, hardness 6–6.5, density 2.71–2.72 and a “Tough” tenacity, from Tetela de Xonotla, Mexico.
In short
- The formula, checked. The September 2026 IMA-CNMNC Master List lists xonotlite as Ca6Si6O17(OH)2, grandfathered, 1866, Mexico, and the Handbook of Mineralogy sheet writes the same. Worked on standard atomic weights it is 47.06% CaO, 50.42% SiO2 and 2.52% H2O, the sheet’s ideal column exactly. The cell it prints gives a density of 2.707 by script, against 2.71 calculated and 2.71–2.72 measured.
- The one-water identity. Six CaSiO3, wollastonite’s formula, plus one H2O is Ca6Si6O18H2O, the same atoms as Ca6Si6O17(OH)2: formula masses 714.98 both ways. So xonotlite has wollastonite’s 1-to-1 calcium-to-silicon ratio, and its water shows up on the balance: a 20.00 g piece reads 12.62–12.65 g in water against wollastonite’s 13.01–13.53 g, at least 0.36 g apart.
- The water ladder. Across nine calcium silicate formulas on the IMA list, by script, water runs from 0% (wollastonite) through 2.52% (xonotlite), 2.71% (pectolite), 4.26% (foshagite) and 9.47% (hillebrandite) to 12.08% (gyrolite), 12.32% (tobermorite), 16.49% (okenite) and 19.26% (nekoite); measured density broadly falls, from 2.86–3.09 to 2.21–2.24. Eight of the nine sheets use the word fibrous.
- Documented failure: the balance. Foshagite, 2.73, reads 12.67 g for 20.00 g and hillebrandite 12.48–12.57 g: within 0.03 g and 0.05 g of xonotlite, so weighing cannot name these white fibrous calcium silicates. Their printed lowest indices do separate them, 1.581–1.583 against 1.594 and 1.605. And the type analysis from Tetela de Xonotla carries 3.70% water, 1.49 waters per 6 Si, not the formula’s 1.
- Gem, uses, care. The International Gem Society xonotlite article says lapidaries have cut translucent faceted stones of several carats from Italian material and that synthetic xonotlite has been used in powder form for “absorption, insulation, and pigment extension”. Fibrous habits are routed in one line to toxic minerals in a collection; that is not advice. We hold no catalogue and nothing here is offered for sale; the wanted list is the only commercial route.
| Mineral | IMA formula | Ca/Si | Water as H2O, % by mass | Density (sheet, measured) | 20.00 g in water | Fibrous on the sheet? |
|---|---|---|---|---|---|---|
| Wollastonite | CaSiO3 | 1.000 | 0 | 2.86–3.09 | 13.01–13.53 g | Yes: “parallel fibrous” |
| Xonotlite | Ca6Si6O17(OH)2 | 1.000 | 2.52 | 2.71–2.72 | 12.62–12.65 g | Yes: “flaky fibrous radiating bundles” |
| Pectolite | NaCa2Si3O8(OH) | 0.667 | 2.71 | 2.84–2.90 | 12.96–13.10 g | Yes: “radiating fibrous” |
| Foshagite | Ca4(SiO3)3(OH)2 | 1.333 | 4.26 | 2.73 | 12.67 g | Yes: “fibrous and in compact masses” |
| Hillebrandite | Ca2SiO3(OH)2 | 2.000 | 9.47 | 2.66–2.69 | 12.48–12.57 g | Yes: “Acicular fibrous crystals” |
| Gyrolite | NaCa16(Si23Al)O60(OH)8(H2O)14 | 0.696 | 12.08 | 2.388–2.390 | 11.62–11.63 g | Yes: “fibrous layers” |
| Tobermorite | Ca4Si6O17(H2O)2·(Ca·3H2O) | 0.833 | 12.32 | 2.423–2.458 | 11.75–11.86 g | Yes: “fibrous bundles” |
| Okenite | Ca10Si18O46(H2O)18 | 0.556 | 16.49 | 2.28–2.33 | 11.23–11.42 g | Yes: “typically fibrous” |
| Nekoite | Ca3Si6O15(H2O)5·2H2O | 0.500 | 19.26 | 2.21–2.24 | 10.95–11.07 g | No: “fine, slender needles” |
| Xonotlite, Tetela de Xonotla analysis | Per 6 Si: Ca 5.648, Mn 0.183, Fe 0.133 | 0.941 (Ca only) | 3.70 (printed) | — | — | Type locality; 1.49 waters per 6 Si |
What is the formula of xonotlite? Six wollastonites and one water
Two sources, one formula. The September 2026 IMA-CNMNC Master List gives Ca6Si6O17(OH)2, status G, first described in 1866, Mexico; the Handbook of Mineralogy xonotlite sheet heads its page with the same. Worked on standard atomic weights the formula mass is 714.98 and the oxides are CaO 47.06%, SiO2 50.42% and H2O 2.52%, which is the sheet’s ideal column (2) exactly. By element it is 33.63% calcium and 23.57% silicon.
The identity. Write wollastonite’s CaSiO3 six times and add one water: Ca6Si6O18 + H2O. Move one oxygen and the two hydrogens into hydroxyl and it reads Ca6Si6O17(OH)2. The two sides have the same atoms and the same mass, 714.98, so the calcium-to-silicon ratio is 1 to 1 in both. The arithmetic says nothing about the structure, which the sheet’s reference (3), Eberhard and co-authors (1981), writes Ca6[Si6O17](OH)2; it only says that xonotlite is wollastonite’s composition plus 2.52% water. The two minerals are named together on the sheet: wollastonite is among xonotlite’s associates.
How hard and how heavy is xonotlite? The water ladder
In the hand. The sheet gives needlelike crystals elongated ∥ [010], to 2 cm, flaky fibrous radiating bundles and rosettes, massive material, a perfect cleavage in one {h0l} direction, splintery fracture and a “Tough” tenacity, with hardness 6–6.5. The International Gem Society xonotlite article gives hardness 6 and repeats the point: “They have a "tough" tenacity, while most gemstones only rank as "brittle."” Colour runs chalky white to bluish gray and pale pink, “fading on exposure”; lustre is pearly or greasy. The differences between cleavage and fracture are on cleavage, parting or fracture.
The ladder. Ordered by water worked from the IMA formulas, the calcium silicates with cached sheets run wollastonite 0%, xonotlite 2.52%, pectolite 2.71%, foshagite 4.26%, hillebrandite 9.47%, gyrolite 12.08%, tobermorite 12.32%, okenite 16.49% and nekoite 19.26%. Measured density broadly falls the same way, from wollastonite’s 2.86–3.09 to nekoite’s 2.21–2.24, and a 20.00 g piece goes from 13.01–13.53 g in water to 10.95–11.07 g. Xonotlite at 12.62–12.65 g sits 0.36 g below wollastonite and 0.31 g below pectolite, whose figures agree with wollastonite and pectolite. The method is on how to measure specific gravity at home.
Where the ladder fails: foshagite, hillebrandite and the type analysis
Documented failure: three readings within 0.19 g. Foshagite, Ca4(SiO3)3(OH)2, reads 12.67 g for 20.00 g and hillebrandite, Ca2SiO3(OH)2, 12.48–12.57 g. Xonotlite’s 12.62–12.65 g lies within 0.03 g of the first and 0.05 g of the second, a spread far smaller than the 0.36 g that separates it from wollastonite. All three sheets print fibrous or acicular habits and white colours, and foshagite’s crystals are also “elongated along [010]”. What separates them on paper is optics: the lowest printed index is 1.581–1.583 for xonotlite, 1.594 for foshagite and 1.605 for hillebrandite, and foshagite is printed at hardness 3 when massive. Those are laboratory readings, not hand tests.
Documented failure: the type material is wetter than its formula. The sheet’s analysis (1), from Tetela de Xonotla, prints SiO2 49.58, CaO 43.56, MnO 1.79, FeO 1.31 and H2O 3.70. Recast by script to 6 silicon, that is Ca 5.648, Mn 0.183 and Fe 0.133, a sum of 5.964 against the formula’s 6, with calcium 94.7% of it, and 1.49 waters against the formula’s 1. The ideal 2.52% water is the sheet’s calculated column, not this analysis.
Where is xonotlite found?
The Distribution field. The sheet opens “Many localities” and names Tetela de Xonotla, Puebla, Mexico; in the USA, Leesburg, Loudoun Co., Virginia, Franklin, Sussex Co., New Jersey, the Hunting Hill quarry, Rockland, Maryland, Isle Royale, Lake Superior, Michigan, Crestmore, Riverside Co., California, and Christmas, Gila Co., Arizona; Point Shivery, Bay of Islands, Newfoundland; near Yauco, Puerto Rico; Arsiero, Vicenza, Italy; Scawt Hill, near Larne, Co. Antrim, Ireland; Broadford, Isle of Skye, Scotland; Marrait, Greenland; Hashidate and Kotaki, Niigata, Kaisuka, Chiba, and the Mihara mine, Okayama, Japan; and the Wessels and N’Chwaning mines, near Kuruman, South Africa.
Setting. Contact metamorphic deposits in limestones, serpentinites and metavolcanic rocks, with tobermorite, clinohedrite, wollastonite, diopside, thaumasite, laumontite, stilbite and apophyllite as associates. Scawt Hill also appears in the wollastonite sheet’s Distribution, and Crestmore in foshagite’s X-ray pattern. The sheet has no separate type-locality line; its Name field gives Tetela de Xonotla as the place of first description, and the term is explained on what is a type locality.
Is xonotlite a gemstone, and what is it used for?
Gemstone. The International Gem Society xonotlite article (Joel E. Arem, updated 19 April 2022) says “Lapidaries have cut translucent (not truly transparent) faceted stones up to several carats in size from Italian material” and that “Mexico and the Vicenza region of Italy have produced gem-quality, facetable material”, while “you’re more likely to find these stones in mineral collections than in jewelry collections.” It reports “no known treatments or enhancements”. No fetched gemmological source compares xonotlite with larimar, so this page does not; larimar is blue pectolite on pectolite, and the related question is on is hemimorphite the same as larimar.
Uses. The same article: “Researchers have synthesized xonotlite via the hydrothermal method. The synthetic material has been used in powder form for industrial purposes, such as absorption, insulation, and pigment extension.” No USGS or BGS text on xonotlite was fetched, so this page says nothing more about industrial use. Hazard questions about fibrous minerals go to toxic minerals in a collection and the asbestos definition is read on is wollastonite asbestos; neither is advice. Zeolite neighbours are on which minerals are zeolites and is okenite a zeolite; more species are in the species index. We hold no catalogue and nothing here is offered for sale; the wanted list is the only commercial route.